This is a community radio relay.

This box is a MeshCore node — a small LoRa radio that relays short text messages between other nodes on the network. No cell service or internet needed on either end.

It's run by a local volunteer. It cannot see you, record you, or track your location.

MeshCore is open-source firmware for low-cost LoRa radios. Messages hop between nodes automatically — no cell tower, no internet, no monthly bill. Range in town is a few miles; from a hilltop, 30+ miles isn't unusual. The Palouse is actually well-suited for this.

If you want to join the network yourself, a compatible radio and the free MeshCore app are all you need. See the Client Setup guide to get started, or check the FAQ for common questions.

Meshtastic and MeshCore run on similar hardware but different firmware — they can't talk to each other directly. Good news: most common LoRa boards support MeshCore. Check meshcore.io/flasher to see if yours is listed — a firmware swap is usually all it takes.

Not sure what you have? The app you used to set it up tells you: Meshtastic app = Meshtastic firmware, MeshCore app = MeshCore firmware.

• Client Setup — flash firmware and connect the app
• Repeater Setup — add a relay node to extend coverage
• Channel Directory — all active channels and QR codes
• FAQ — hardware, range, licensing, and more

• map.palouse-mesh.net — live node map
• beacon.palouse-mesh.net — packet analytics
• puw.meshmapper.net — MeshMapper regional view

• Palouse Mesh — Facebook Group
• Inland NW Mesh — regional wiki & resources